2.5" Budget Boost Lift Kit
by JGCParts
This is safest, and easiest way to fit more aggressive, larger diameter wheels and tires under your 1999 - 2004 WJ
Grand Cherokee
®. Ride quality is as good as factory, plus there is no need to change out your shocks, brake lines or
control arms. That makes our kit the best on the market, and the easiest on your wallet. Because it's so easy to install,
an average Jeep
® owner can complete this job in under 2 hours. The hardest part is convincing yourself you can
actually do it. Read through the steps below to see how easy it can be.
Application: 1999 - 2004 Jeep® Grand Cherokee®
Front coil spring spacer installation instructions

Read the instructions before beginning installation. The following tools are recommended:
Coil spring compressor, floor jack, jack stands, and metric wrenches/sockets

- Jack the front of the Grand Cherokee
® up by the center of the axle.
Complete set of four to lift your 99-04 JGC

Lifetime warranty for peace of mind.

Lift it right the first time with JGCParts.
Improves ground clearance without sacrificing load-carrying capacity. Water proof, and oil resistant materials make
these ideal for daily use vehicles, and off-road weekend trail explorers. Clear up to 31" tires with no trimming, and
32" with minor trimming. Can be used with other lift kits for even more travel!
Complete set of four to lift your 99-04
Jeep® Grand Cherokee®

Lifetime warranty for peace of mind.

Lift it right the first time with JGCParts.
Budget Boost Lift Kit
-Remove the lower shock nuts that secure the
shock to the axle on both sides.
- Jack the front of the Grand Cherokee® up by the
center of the axle. -Support the vehicle with jack
stands on the frame behind the control arms so that
the front tire/wheels are off the ground freely. You can
either remove the front wheels for more work room, or
leave them on.
-Remove the coil spring.
-Remove the upper coil spring isolator and install onto
the coil spring spacers.
-Starting on one side of the vehicle, install the coil
spring spacer onto the frame.
-Install the coil spring.
- Complete both sides of the Jeep® by repeating the steps
for removal and spacer installation. Jack the axle up, and
reconnect the shocks. If removed, install the front
tires/wheels and lower the vehicle onto the ground.
- Test drive your Grand Cherokee®. If needed, have the
front end alignment checked and adjusted after installing the
JGCParts budget boost coil spring spacer lift kit.
Dual Zone Heater Repair Kit
Crystal Lenses Headlamp Solution
Budget Boost Lift Kit
6pc Prylon Combo Kit (4-Orange/2-Steel)
* Chrysler Group LLC has neither licensed nor endorsed JGCParts to sell goods and services for Jeep® vehicles.
Jeep® and Grand Cherokee® are registered trademarks of Chrysler Group LLC. JGCParts is not in any way
associated with Jeep® or Chrysler Group LLC.